Surface Preparation
• The surface must be strong, clean, dry, free from oil, dust, rust, curing agents, paint, or any contaminants. The surface should not be loose. Repair cracks with suitable materials and level the surface to avoid standing water.
• For repair works with an existing waterproofing system, remove the old waterproofing layer before application to ensure the best performance of the new system.
• If the surface is too dry, dampen it with water to cure the concrete before application, but make sure there is no standing water during the work.

Mixing
• Mix 2.5 kg of the product with 1 kg of clean water. Stir thoroughly using a low-speed mixer (not exceeding 400 rpm) until a uniform consistency is achieved. Let it sit briefly to release air bubbles before application.

Application
• Apply the mixture with a stiff brush at a rate of 1.0–1.5 kg/m². Each coat should not exceed 1 mm in thickness. Allow 2–3 hours for drying.
• Apply the second coat in the same way but in a direction perpendicular to the first coat. A sponge can be used to smoothen the surface finish.

Curing
• Protect the waterproofing layer from rain until fully hardened. Cure with moisture for 3–4 days.
• For water tanks, apply inside the tank. It can be filled with water within 5–7 days, but rinse with clean water before use.
• In bathrooms or swimming pools, tiling can be done 3–5 days after application.