Surface Preparation
• The surface must be strong, clean, and dry, free from oil stains, dust, rust, curing agents, paint, loose cement particles, or any contaminants. No primer is required.

Mixing Procedure
• Mix Part A and Part B at a weight ratio of 3:1 using a low-speed drill for 2 minutes. For small quantities, mixing can be done with a paddle or trowel. Ensure the mixture is thoroughly blended into a uniform consistency.

Application Procedure
• Use a putty knife to apply the material into joints or gaps, spreading it at least 2–3 cm beyond each side of the joint for easier finishing.
• For deep or through joints, insert a backing rod at the bottom before applying the filler.
• Allow to dry for at least 8–12 hours, then sand with fine sandpaper to smooth the surface.
• The surface can be painted over or finished with other materials.
Coverage rate – approximately 6 meters per 1 kilogram (for joints sized 1×1 cm).

Post-Use Cleaning
• After use, all tools and equipment should be cleaned with thinner.